Interesting. Problem is that if I include the "blaster" section (or, it
seems, any part of it), irsend stops recognizing anything.

For example, if I remove the entire section for "blaster":

$ irsend LIST "" ""
irsend: Hauppauge
irsend: hauppauge_pvr
irsend: Hauppauge_350
irsend: Hauppauge_WinTV_Nexus-S
irsend: Hauppauge

If I include the blaster section in its entirety:

$ irsend LIST "" ""
(nothing)

If I replace the hauppauge_pvr codes with blaster codes, replacing
"begin codes" with "begin raw_codes" and continuing until "end raw_codes":

$ irsend LIST "" ""
(nothing)

If I replace the hauppauge_pvr codes with blaster codes, leaving the
"begin codes" and "end codes":

$ irsend LIST "" ""
(nothing)

If I download the lircd.conf from http://www.blushingpenguin.com/mark/lmilk/lircd.conf  and try that,
unaltered:

$ irsend LIST "" ""
(nothing)

Why should this be? How can I send a blaster code?

--

Kind regards,

Martin

No clue, it works for me... (Or at least, did last I tried it). I was thining
perhaps an error in your config somewhere, but if you're using the downloaed
config w/o any changes, that doesn't seem like a possibility. I'll be poking
at this shortly (later today, I hope), with an HVR-1950, will see what I can
see then...

--
Jarod Wilson
jarod*******